The controllers are so bulky that I had to buy the open orange plates and cut them to fit around the controllers and install them in the wall. Also, one of the 6 was broke so I purchased another controller locally.
This is a great set for the money. The sound is very nice and installation of the speakers is very easy. However, the volume switches are a bear. They barely fit in a new work electrical box. They will not fit in a rework electrical box or short box. I suppose you could just not use an electrical box but they discourage this in the instructions. What I did. If you plan on using an electrical box get the new work box with the nails. Remove the nails and cut off the nail holders. Also cut the wire run hole bigger to allow room for the wires later. You will now need to find a stud on your wall and cut a hole for the box along one side of the stud. Run the wires you need through hole in the wall and the electrical box with a bit of slack. Not too much as it's tough to push much wire back once you attach the switch. Screw the box diagonally from the inside of the box to the stud. Connect wires to the switch with minimal slack. Now carefully push switch into box wiggle wiggle wiggle. Mount the switch to the electrical box with short dry wall screws instead of the screws they give. Test it and cross your fingers. By the time you get to the final box you'll be a master. Good luck. Hope this helps someone.
Good value for the price. The 6 volume controls and the speaker selector unit included within this package make this a very good buy. The speaker quality is good and the box indicates a 5 year warranty from PYLE. I installed these speakers (one in each major room of my home) connected to the PYLE Pro PT-8000CH amp (also from Overstock) and tied it into my home theater system. This gives me the ability to listen to music from DVR/Cable box, TV, MP3 / IPOD, FM, CD's etc. throughout my home. I ended up contacting PYLE for a switch setting on the volume control so as to match the speakers impedance as this info was not in the box. (from the Volume control output terminals side of the selector switch 4,6,8,10 ohms are the available settings) All and all I am happy with the product and would recommend to others based on my experience.
If you need further help or information please visit our Online Help Center