Upon opening the parts you take a deep breath and think "this doesn't look so bad"... and it is down hill from there. The worst part is that the iron/metal is not symetrical. Therefore, no matter how much effort you put into assemeling it perfectly the legs aren't even and the thing teeters back and forth. They do include 4 leveling feet, but they should have made them about 12" long if they are to level that piece of junk. I ended up almost pulling my back out trying to bend and straighten the metal enough so that the table would rest on all four feet. I finally did bend and pull enough to get it close enough for the leveling feet to do their job and then realized that the female end of the threading for the feet was cross threaded and the feet couldn't be used. I would highly recommend passing on this tempting and nice looking (in the photo) piece.