This cabinet is pretty darn cute! Assembly was OK, but 4 dowels were way too narrow (part K 3/16x1-3/16 ) for such wide holes that were predrilled, (the lengths were OK) and had to use larger(fatter) ones that I happened to have on hand. I hated the cardboard slide-in back panel, as it is 2 pieces TAPED together, which is visible from inside. YIKES! It would not seat properly, I had to sand it down a little off top edge to get it to seat. If it had seated it would have fit but I just couldn't get it to seat.. I might replace it. Instructions and hardware indicate you can mount to wall through that flimsy back panel, if I do that I will certainly replace it with something more sturdy and 1 piece. Be very careful to not over-tighten/drive anything too much. And make sure cam bolts are very straight going in. I glued dowels and some joints after a dry assembly run. Makes these things much more stable. I bought this cabinet because of its height but it was still one one inch too tall, although it looked like I could saw legs down without being noticeable. I taped (masking) off before cuts to reduce chips, and it worked/looks great and does not look cheap. As with most of these things it looks like I will have to fiddle with door hinges to get it perfect. All in all I like this cabinet.
- How did the color on site compare with the actual product? Accurate
- Please tell us about the quality of the product. Better than some
- How accurate was the on site description of the product? Accurate