1.the drawer system is a problem but here is the solutions... first of all make sure you put the total drawer system together so you can test it before you move on...as you make the drawers check out how much space you have from the top of the drawer and the bottom...the longer part should be at the bottom.... 2. the scanner part is confusing to put together... to dislodge the pieces...push the black piece up or down depending on how you are looking at it..I'm talking about the black peice that is sticking out....or it looks like a stick.... this will dislodge the piece..the heavy piece is 4a and the other piece is 4b...I had a problem because I couldn't figure how to access the holes on the 4a piece...if you look at the piece you will see ball bearing on both sides of the rail, their can be moved up or down... once you move these then you will be able to get access to the hole at the front.... 3. I put all the board's in three piles and guest what you use the part's in order for the most part.... I like this desk..but it was a pain to put together...took about 6 hours by myself........I didn't like it but I was satisfied when I was finished...also please note the the cpu opening is to small for my full atx computer case..of course it should fit a micro atx case......but I doubt it if I will.... I would recommend this product to a friend if he or she like a challenge or if I was to help with the assemblying.
- Would you recommend this to a friend? Yes