- Page 1 of 1
- Sort by:
- Page 1 of 1
- Sort by:
Dec 24, 2011
iscpa18 from Los Angeles, Rating:1.0This lightbox is poorly designed and made. Through shipping the welds were loosen and deformed. The plexiglass would into the box since the rails were too far apart because of the deformation. The light switches would not work unless you held them down for an uncomfortably long time. The leg unit was not worth the almost $$$ charge. The total amount of light is inadequate.
Aug 13, 2011
ootopo from Los Angeles, CA, Rating:4.0This bulb is a direct replacement for MR-16. Light output is very bright. The only issue is that once in a while it will "hiccup" and go into "limp" mode, showing about only 10% of its normal light output. A cycling of the On/Off switch cures it.
Jun 23, 2011
jimmyjohnson from Florida, Rating:1.0The LED bulbs were poor quality with several "bulbs" not working. Also the size of the fixture would Not fit many of the intended uses as the "bulb" was just much too BIG to fit the standard fixtures they were intended for. If they could make them about 1/2 the size they might fit something. They they just need to make sure they send working lights.
Aug 6, 2010
nwgrrl from Lynnwood, WA, Rating:1.0I've tried to find LED lights to fit the two hallogen fixtures over the island in my kitchen. The bulbs I found at the local store didn't fit. These fit but the light is ... not very illuminating. If I were to exaggerate, I'd say the difference between the old bulbs and these bulbs is day and night, but to be wholly accurate, the difference is more like going from the normal light of a hallogen to the dim light of a single christmas tree bulb. These do not work as a substitute.
May 11, 2010
nealito from TX, Rating:1.0Bulb photo did not show connection in back. Cannot use the connection it has. Not worth sending back.
View More Recent Reviews