Stanley King-size Bed

Good bed. Nice finish. Dark brown color. Solid once assembled. Ships in two boxes - one smaller but long frame box about 4" square but 8' long with its parts and then one very large (two people to move) 4' by 8' by 3" thick box that contains the headboard, footboard and its assembly and decorative parts. Frame is your typical one size for every mattress size that snaps together in the center rail. Use the outer holes in the center piece when it snaps together. No tools are needed. The frame on its own is a little wobbly but that's because the headboard and footboard aren't yet attached to stabilize everything. Now, the headboard/footboard attachment. The manufacturer cheats a little in that the headboard and footboard pieces are the exact same size. The headboard height is created by adding an extension leg on the bottom of each side and then those extension legs are what actually attaches to the frame. Note the headboard itself does *not* have any attachment holes. We attached the extension legs to the frame first, then placed the headboard over the legs then pressed down *hard* on the frame post at each end at the same time to compress the frame onto the extension legs. We thought it was easier to do it this way then trying to push the extension legs up into the headboard first or trying to do the compression without the extension legs attached. When the headboard is completely pressed down on the legs, there should be nothing but the joint of the two pieces - you should no longer see any of the inside smaller parts of the extension legs as you do before compressing the headboard onto the legs. If you don't compress hard enough, the headboard itself will rock a little as it's not tight enough with the extension legs. Press down HARD. I even considered a rubber mallet on the each end but we managed to compress it down far enough without needed the it. The headboard attaches to the frame via four long bolts/washer/nut. The bolt is an allen wrench bolt (allen wrench is included in the parts box) but the nut itself is a 10mm nut (no wrench comes in the kit for that). The instructions say to just use the allen wrench to tighten but I wanted to hold the nut too while tightening it all down. The footboard itself has the mounting holes in it and uses the shorter of the bolts and the allen wrench. Just screw the footboard to the frame. Finials then screw into the four posts at each corner. The footboard also has little decorative cups that the legs sit in. Note that you can see the feet of the frame after bed is assembled so you might want a longer bed skirt or something to block seeing them if you don't care for the exposed look. Not too tough to assemble but pay attention that the headboard has no mounting holes on it and the footboard does. That's the only way to tell them apart. The instructions also don't focus on the headboard first and then the footboard. It combines the assembly of the two in each of the steps so read through the instructions a few times so you know exactly what piece goes where.