Modern 38-inch Black Mesh Coffee Table

Rating

my unit arrived in superb condition, it looks exactly as pictured, thanks. assembly was relatively simple.

Rating

I am happy with this table. I bought if for a guest bedroom to use with a convertible sofa bed. It sits low to the ground so I needed a low table that was lightweight enough to easily move out of the way. Nice that the tray holds reading material. You could also place a small plant in the mesh tray. I had absolutely no issues putting it together. The feet screw in so if you have issues with it being unlevel, they can be adjusted.

Rating

That likes very nice and modern. It is a little small (38 inch) but perfect in my no so big living room.

Rating

When I ordered this table, I was weary after I read the reviews regarding the assembly of this product. So I took a deep breath, opened the box and was very surprised that it only took me 25 minutes to put it together, well. I advise not to tighten the screws totally until you are sure it's sqared off and even. The table is smaller than I imagined but it will work well in a small space, with an apartment sized sofa or loveseat. It looks much nicer than the picture, I recommend it. Delivery was prompt, no damages or missing pieces. Thank you Overstock!

Rating

Please notice the add gives two size for the length: 38 and 42, both wrong. The table is 37. This may work for me as I wanted something pretty small, but just be aware.Assembly is a pain due to poor design. It takes some creative approach and if you are not good with your hands you will end up with an uneven table (like the other folks said) due to poor design.Overall look, once you got it right (I had to take it apart again to fix the uneven feet problem) is not too bad, it looks nice and "designer" like, so it is ok if you need a SMALL coffee table.PS: the little nylon washers go in FIRST: screw the four metal rods, THEN insert the little nylon washers, THEN put in the chrome tubes. Assemble the two arch legs onto the center pieces before attempting to put it all together. It may be difficult (impossible, really) to shove the metal rods through the little holes. My suggestion is that you get them as far down as you can (they catch on the screw threads, nothing you can do about it, you can't tap it because you would be tapping AGAINST the glass base) and then use a REAL wrench and start torquing the nuts slowly. THis will force the assembly past the stud threads.good luck

• How often do you shop at Overstock.com? First time
• Are you a Club O Member? No