As an Omail subscriber, you will receive several benefits, including:
Omail Exclusive Coupons like free shipping and 10% off
Site-wide Promotion Notifications including $1 shipping
Personalized Product Recommendations
I used this to mount an ACER X1261P to the ceiling. It did not have the required screws to attach the Acer to the mount, I had to pull screws from a different make and model of projector mount. The addition of two down connectors (poles) was nice, I needed the longer one since I was mounting to floor joists above a drop ceiling, and needed to drop the projector below the finished ceiling. The mounts description says that it could shift the projector from side to side, but that feature is not available on this unit. The mounting design is not quite as good as other mounts I have used as the adjustment options are not sufficient to install the mount at the projector center of gravity, although I got pretty close. This makes the projector want to drift in alignment, unless you tighten the adjustment nuts down well, which makes it harder to adjust. The adjustment design is friction based, you have to set the friction of the mount adjustment motion before you install the mount, and then adjust the mount once you have the projector mounted on it; it is not possible to tighten the adjustment securely once you have it adjusted, so it can get knocked out of alignment easily if bumped. The manual left a lot to be desired, quite a bit of inference is needed to fill in the gaps not covered concerning installation and adjustment. This was the cheapest projector mount I could find, and I found it a fair value.
This mount may be ok for projectors that are mounted in the center of the unit, but my particular projector has the mounting screws off centered to the right. Overstock doesn't do a very good job of describing how the tilt/roll works on this unit. It uses a rubber seal and a tightening screw to adjust tilt/roll which is accessed on the inside of the down rod. It is not strong enough to hold an "off centered mounted projector" with the way it's factory set. This made it extremely difficult to mount as I had to take the projector down multiple times to get the right set. Once I got it where I needed it, I took the projector down and wrenched down on the screw to tighten the rubber seal. After only a week of being mounted, I noticed the picture to be off centered slightly. I can't wrench the tightening screw down much more, which means it will always need to be adjusted every couple weeks! I jerryrigged it with some string from the outside of the projector to the top of the mount which has seemed to help displace the weight of the projector. I would return it but I don't have the cash to buy another while I wait for this to be returned, and with Overstocks unsatisfying return policy, it being opened I can't get a full refund or shipping refunded for it anyway :( Please, do your self a favor and stay away from this mount. For just $10 more there is a mount on this site that has separate nut and bolt actuating tilt/roll adjustment that would work a heck of a lot better!
The items must arrive at our warehouse within 30 days of purchase. You must return items in their original condition to qualify for a full refund. We will issue a partial refund of up to 70 percent if returned items have been opened, used, or returned late. More details
Our standard shipping method is ground shipping. You should receive your products within 5-10 business days from the day you order them.
More details
We offer Next Day, 2 Day, and 3 Day shipping for most items. Expedited shipping is not available for items being shipped to PO Boxes or APO/FPO destinations. For more information on this please view our Expedited Shipping page.
More details
* For your safety, some orders go through our loss prevention department. If we select your order for this process, we will immediately notify you that there may be up to a 3-day delay on your order.
** Most Oversize orders are delivered within 1-4 weeks. Some orders may take 6 weeks to be delivered.
Type your tag below and press enter or comma.